Value Collection BDC87691 Rubber Grommet 25 Pack

Product Description

The VALUE COLLECTION BDC87691 is a rubber grommet designed to protect wires, cables, tubing, and hoses where they pass through holes in sheet metal panels, enclosures, and equipment frames. The grommet seats into a 3/4-inch slot diameter opening and accepts material up to 1/8 inch slot width, with a 1/2-inch inside diameter to accommodate the routed component. Rubber construction provides electrical insulation, vibration dampening, and edge protection against abrasion and cutting. Each pack contains 25 grommets. HVAC technicians, electricians, and plumbers install these during panel fabrication and field service work where wiring or tubing penetrates metal surfaces.

This grommet is suited for use in control panels, electrical enclosures, HVAC equipment cabinets, junction boxes, and plumbing or refrigeration equipment frames. Any application where a cable, wire bundle, or small-diameter tube transitions through a punched or drilled hole benefits from edge protection. The 25-count pack quantity makes it practical for stocking on a service vehicle or in a shop parts bin for recurring use across multiple jobs.

Key Features

• Rubber material provides flexible fit, electrical insulation, and abrasion resistance at the panel edge
• 3/4-inch slot diameter matches standard punched-hole sizing common in sheet metal enclosures
• 1/2-inch inside diameter accommodates typical wire bundles and small tubing
• 1/8-inch slot width secures the grommet in place within standard-gauge sheet metal
• 25 grommets per pack supports multi-job stocking and reduces per-unit cost on volume work

Compatibility

Designed as a standard rubber grommet for use in sheet metal panels, electrical enclosures, HVAC equipment cabinets, and similar fabricated metal assemblies with a 3/4-inch slot diameter hole.

Installation Notes

Grommets of this type are installed by electricians, HVAC technicians, and plumbers during equipment assembly or field service. Confirm the panel hole diameter matches the 3/4-inch slot diameter before installation. Press the grommet firmly into the hole until the outer lip seats flush against both faces of the panel. Route wiring and cables only after the grommet is fully seated to avoid displacing it during pull-through.