Value Collection BD-C403605 Square Ring Terminal 2/0 Awg

Product Description

The VALUE COLLECTION BD-C403605 is a non-insulated square ring terminal designed for heavy-gauge wire termination in electrical panels, industrial control wiring, and power distribution assemblies. Built with a copper contact body and titanium nitride (TiN) plating, this crimp-style terminal provides a reliable mechanical and electrical connection on 2/0 AWG wire. At 2.28 inches long and 0.83 inches wide, the square ring geometry allows for secure bolt-down mounting on bus bars and terminal blocks. It is installed by licensed electricians and experienced electrical contractors working on high-current applications.

This terminal is suited for residential service entrance work, commercial panel builds, and industrial power wiring where 2/0 AWG conductors are used. The square ring profile seats flat against mounting surfaces, making it a practical choice for bus bar connections, grounding lugs, and battery cable terminations. Each package contains 5 terminals, supporting multi-point installations or keeping spares on hand for service work. The non-insulated design is appropriate where heat-shrink or separate insulation sleeves will be applied after crimping.

Key Features

• Non-insulated square ring design for bolt-down termination on bus bars and terminal blocks
• Copper contact material for low-resistance electrical connections on high-current circuits
• Titanium nitride (TiN) contact plating for corrosion resistance and enhanced durability
• Crimp connection type compatible with 2/0 AWG wire
• Overall length of 2.28 inches and ring width of 0.83 inches for a consistent, repeatable fit
• Sold in a 5-piece pack for multi-point or service inventory needs

Compatibility

Designed as an OEM-style replacement and standard-use crimp terminal for non-insulated square ring applications on 2/0 AWG conductors in electrical power and control wiring systems.

Installation Notes

Installation should be performed by a licensed electrician in accordance with NEC requirements for the applicable circuit voltage and ampacity. De-energize and lock out the circuit before terminating or replacing any ring terminal. Use a calibrated ratcheting crimp tool rated for the 2/0 AWG die range to ensure a proper crimp. Do not solder over the crimp joint, as this can introduce brittleness and void the mechanical connection integrity.