Value Collection BD-32581 Steel Bundle Clamp 25-pack

Product Description

The VALUE COLLECTION BD-32581 is a steel bundle clamp designed to secure wire bundles, tubing, or cable groups to a fixed surface using a standard fastener. Built from steel with a black finish, this clamp accommodates a maximum bundle diameter of 1/4 inch and mounts through a 3/8 inch hole. It is 3/4 inches wide and rated for operating temperatures from 20 degrees F to 350 degrees F, making it suitable for a wide range of service environments. Electricians, HVAC technicians, and plumbers use this type of clamp to organize and anchor low-voltage wire bundles, refrigerant line sets, or small-diameter tubing runs during installation and service work.

This clamp is a standard fastener-mount style used in both residential and commercial applications wherever neat, secure bundling is required. Typical install scenarios include panel rough-ins, mechanical room wire management, equipment service connections, and conduit-adjacent bundling where a separate clamp is needed to hold a secondary run in place. Sold in a pack of 25 units, this SKU suits stocking needs for ongoing service or new construction work.

Key Features

• Steel construction with black finish for durability across a wide temperature range
• Accommodates bundle diameters up to 1/4 inch
• 3/8 inch mounting hole for fastener attachment to panels, framing, or equipment surfaces
• 3/4 inch clamp width provides stable support without excessive footprint
• Rated from 20 degrees F to 350 degrees F minimum and maximum operating temperature
• Pack of 25 units supports stocking and bulk service use

Compatibility

Designed as an OEM-style replacement or service-stock bundle clamp suitable for fastener-mount applications requiring a 3/8 inch mounting hole and a maximum 1/4 inch bundle diameter.

Installation Notes

Installation is performed by licensed electricians, HVAC technicians, or plumbers depending on the system being serviced. De-energize all circuits and shut off fluid supply lines before securing or repositioning any bundled cables or tubing. Use a fastener appropriate for the mounting surface material and ensure the clamp is seated flush before tightening. Follow applicable NEC or local mechanical code requirements for bundle support spacing and hardware specifications.