Value Collection B7S075C375 Fully Threaded Stud 3/4-10

Product Description

The VALUE COLLECTION B7S075C375 is a fully threaded stud machined from Grade B7 alloy steel with an uncoated finish. It carries a 3/4-10 UNC thread profile across its entire 3.75-inch overall length, meaning there are no plain or reduced shanks — the thread runs end to end. Grade B7 material is a chromium-molybdenum alloy steel known for tensile strength and suitability in elevated-temperature or high-pressure bolted joint applications. The Thread Fit Class is 2A, the standard external thread tolerance class for general-purpose industrial fastener use. Plumbers, pipefitters, HVAC technicians, and maintenance mechanics install these studs in flanged connections, equipment mounts, and structural assemblies where a bolt-through configuration is not practical.

This stud is suited for residential and commercial mechanical applications where a fixed threaded anchor point is needed on both ends. Typical uses include flanged pipe connections, pressure vessel assemblies, pump and equipment bases, and threaded rod applications in HVAC equipment mounting. The uncoated finish is appropriate for dry or controlled indoor environments; additional corrosion protection should be considered for outdoor or wet service conditions. The 3/4-10 thread size is a common coarse-thread designation found throughout trade plumbing, HVAC, and industrial piping systems.

Key Features

• Fully threaded end to end — 3.75 inches of usable thread on a single fastener
• 3/4-10 UNC coarse thread for broad compatibility with standard hex nuts and couplings
• Grade B7 chromium-molybdenum alloy steel for high tensile strength and temperature resistance
• Class 2A thread fit — standard tolerance for general industrial bolted joint assemblies
• Uncoated steel finish suitable for controlled indoor mechanical environments

Compatibility

Designed as a standard fully threaded stud for use with any 3/4-10 UNC threaded nut, coupling nut, or tapped hole meeting ANSI/ASME thread standards. Confirm joint design requirements before installation.

Installation Notes

Fully threaded studs are typically installed by licensed pipefitters, millwrights, or mechanical contractors following applicable ASME or equipment manufacturer torque and joint specifications. Power down and depressurize any system before removing or installing fasteners in pressurized assemblies. Use calibrated torque tools and appropriate thread lubricant or anti-seize compound as required by the joint specification. Do not overtighten; follow the torque values specified by the equipment manufacturer or applicable code for the joint class and material.