Value Collection B52001450 Machine Screw 10-32 Pan Head Phillips

Product Description

The VALUE COLLECTION B52001450 is a 10-32 x 2.25-inch pan head machine screw with a Phillips drive, manufactured from 18-8 stainless steel with a bright, uncoated finish. The 10-32 thread designation indicates a No. 10 diameter with 32 threads per inch, making it a fine-pitch fastener suited for precision assemblies. Length is measured under the head at 2.25 inches. The 18-8 stainless steel construction provides corrosion resistance in moderate environments. This screw ships in a pack of 25 and is installed by maintenance technicians, millwrights, HVAC technicians, and electricians in light fabrication and equipment assembly applications.

This fastener is used in general industrial, commercial, and residential applications wherever a No. 10-32 fine-thread machine screw is specified. Typical uses include panel assembly, equipment enclosures, HVAC cabinet hardware, and electrical control box mounting. The pan head profile provides a low-profile bearing surface with a rounded top, suitable for through-hole or tapped-hole installations. No washer is included or required by the fastener design. The pack quantity of 25 suits both service-call use and light production work.

Key Features

• 10-32 fine thread (No. 10 diameter, 32 threads per inch) for secure engagement in tapped metal
• 2.25-inch length under head for deeper reach in stacked or thicker panel assemblies
• Pan head profile distributes clamping load across a wide bearing surface
• Phillips drive compatible with standard No. 2 Phillips screwdrivers and bits
• 18-8 stainless steel construction resists corrosion in moisture-prone environments
• Bright, uncoated finish — no plating to flake or affect thread tolerance

Compatibility

Designed as a direct replacement or stock fastener for any application specifying a 10-32 x 2.25-inch pan head Phillips machine screw in inch measurement. Fits standard 10-32 tapped holes per ASME B1.1 thread standards.

Installation Notes

Install using a No. 2 Phillips screwdriver or power bit at a controlled torque to avoid stripping the stainless steel threads, which are softer than hardened steel. Power down or de-energize any equipment before fastening screws into electrical enclosures or control panels in accordance with applicable NFPA 70 (NEC) lockout/tagout procedures. Do not cross-thread — hand-start all screws before applying torque. Stainless steel fasteners are susceptible to galling; apply anti-seize compound when assembling into stainless tapped holes if future removal is expected.