Value Collection B240 15X10 Reducing Coupling 1/2x3/8

Product Description

The VALUE COLLECTION B240 15X10 is a black malleable iron reducing coupling designed for threaded pipe connections in gas and liquid distribution systems. Rated at Class 150 with a pressure rating of 300 psi, it steps down from a 1/2-inch to a 3/8-inch threaded connection. The black finish is standard for gas piping applications. This fitting carries a broad set of certifications including FM Approved and cULus Listed, making it suitable for use in commercial and industrial piping systems where code compliance is required. Plumbers, pipefitters, and HVAC technicians install this type of fitting during new construction and service work.

This reducing coupling is used wherever a threaded pipe system requires a size transition between 1/2-inch and 3/8-inch pipe. It is appropriate for residential and light commercial gas lines as well as water and air distribution systems within the Class 150 pressure range. The black finish and malleable iron construction are standard for natural gas and propane piping in accordance with applicable codes.

Key Features

• Malleable iron construction for durability in gas and liquid service
• 300 psi pressure rating suitable for a wide range of piping applications
• Class 150 rated for standard low-pressure piping systems
• Black finish standard for gas piping identification
• Threaded end connections on both 1/2-inch and 3/8-inch ends
• Multi-standard certified: FM Approved, cULus Listed, ABNT, EN 10242, ISO 7/1, GB/T 3287, GB/T 7306.2

Compatibility

Designed as an OEM-style replacement or new-installation fitting for Class 150 threaded malleable iron piping systems carrying gas or liquid media.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with the International Fuel Gas Code (IFGC) or International Plumbing Code (IPC) as applicable. Shut off gas or fluid supply and depressurize the line before removing or installing any threaded fitting. Apply an appropriate thread sealant or PTFE tape rated for the service medium before making up the joint. Do not over-tighten; hand-snug plus wrench turns per standard practice for malleable iron fittings.