Value Collection AT2-16-A Twin Vibration-control Clamp

Product Description

The VALUE COLLECTION AT2-16-A is a twin vibration-control clamp designed to secure and isolate tubing in mechanical systems where vibration damping is required. The clamp body is molded from polypropylene for corrosion resistance and lightweight handling, while the mounting plate is steel for rigid attachment to a surface. It accommodates a tube outer diameter of 5/8 inches and uses a standard mount configuration. At 2.09 inches wide, 1.42 inches high, and 1.18 inches deep, this is a compact clamp suited for tight installations. HVAC technicians, plumbers, and pipefitters install this type of hardware during refrigerant line, hydronic, or general tubing runs where vibration isolation is needed.

This twin clamp is appropriate for residential and light commercial mechanical systems. It is commonly installed along tubing runs to reduce noise transmission and mechanical wear caused by system vibration. The twin configuration allows two tubes of the same outer diameter to be secured side by side with a single mounting point. Standard mount hardware compatibility makes it straightforward to fasten to panels, framing, or mechanical equipment enclosures.

Key Features

• Twin clamp design secures two 5/8 inch OD tubes simultaneously at a single mount point
• Polypropylene clamp body resists corrosion and chemical exposure
• Steel mounting plate provides a rigid, stable base for surface attachment
• Standard mount type compatible with common fastener hardware
• Compact footprint: 2.09 inches wide, 1.42 inches high, 1.18 inches deep
• Lightweight at 0.01 pounds — minimal load addition to tubing support structures

Compatibility

Designed as an OEM-style replacement or new-installation clamp for tubing systems with a 5/8 inch outer diameter requiring vibration isolation and twin-tube support.

Installation Notes

Installation is typically performed by HVAC technicians, plumbers, or pipefitters during tubing runs or system service. Power down or isolate the relevant system before working on refrigerant or pressurized lines. Fasten the steel plate securely to a structural surface using appropriate hardware for the substrate. Verify tube OD matches the 5/8 inch specification before installation to ensure proper clamping and vibration control.