Value Collection AL-08-40-5-C Standard Cable Tie 40 Lb

Product Description

The VALUE COLLECTION AL-08-40-5-C is a standard nylon cable tie designed for bundling and securing wire, hose, and conduit runs in electrical and mechanical installations. At 8.875 inches in overall length with a 40 lb tensile strength rating, this tie handles moderate-duty bundling tasks without bulk. The nylon construction resists moisture and common chemicals, and the green color supports color-coded organization on the job site. Electricians, panel builders, and wire management crews reach for this tie when routing conductors through enclosures, trays, and junction boxes. Each tie measures 0.049 inches thick and 0.14 inches wide, keeping the profile low in tight spaces.

This cable tie is suited for residential and light commercial wire management work, including panel wiring, low-voltage runs, irrigation control wiring, and general conduit bundling. The 2.375-inch maximum bundle diameter accommodates a wide range of conductor groupings. The operating temperature range of -40 degrees F to 185 degrees F makes it appropriate for both interior and exterior installations, including exposed locations that see seasonal temperature swings. Sold individually in a minimum order quantity of 100 pieces, this tie is a standard stocking item for electrical contractors and service technicians.

Key Features

• 40 lb tensile strength for reliable, secure bundling of wire and conduit groups
• 8.875-inch length with up to 2.375-inch maximum bundle diameter
• Nylon construction resists moisture, common chemicals, and abrasion
• Green color supports color-coded wire management and circuit identification
• Operating range of -40 degrees F to 185 degrees F suits indoor and outdoor use
• Meets CE, CSA, cULus, RoHS, UL 181B-C, and SAE AS23190 Mil-Spec standards

Compatibility

Designed as a standard-duty cable tie for general wire management applications in electrical, low-voltage, and mechanical installations where a 40 lb tensile strength and 8.875-inch length are appropriate for the bundle diameter and load requirements.

Installation Notes

Cable ties are installed by electricians and wire management technicians following NEC guidelines for conductor bundling and support. Use a cable tie tensioning tool to achieve consistent pull tension without over-stressing the locking head. Cut flush with side-cutting pliers or a flush-cut tool after tensioning to avoid sharp tail edges. Avoid over-tightening on insulated conductors, as excessive compression can damage insulation.