Value Collection A98132 10-24 X 1/2 Button Head Screw 50pk

Product Description

The VALUE COLLECTION A98132 is a 10-24 x 1/2 inch button head machine screw with a Pin-In Torx drive, manufactured from 18-8 stainless steel with a bright uncoated finish. The 10-24 thread follows the Unified National Coarse (UNC) standard, and length is measured under the head. The low-profile button head reduces snag points in tight assemblies. These fasteners suit electricians, HVAC technicians, plumbers, and general tradespeople who need corrosion-resistant hardware for panel assembly, equipment enclosures, and light structural connections. Each package contains 50 screws.

This screw is appropriate for light-duty mechanical assembly in residential and commercial trade applications. The 18-8 stainless steel construction makes it suitable for environments with moderate moisture exposure, including HVAC equipment enclosures, electrical panels, and plumbing fixture mounting. The Pin-In Torx drive adds tamper resistance, making it a common choice for access panels and utility enclosures where controlled access is required. Sold in a package of 50 units to support typical service and installation quantities.

Key Features

• 10-24 UNC thread for compatibility with standard inch-system tapped holes
• Button head profile provides a low-profile, clean appearance in finished assemblies
• Pin-In Torx drive adds tamper resistance for access panels and utility enclosures
• 18-8 stainless steel construction resists corrosion in moderately wet environments
• Bright uncoated finish maintains dimensional accuracy for precise thread engagement
• Packaged in quantities of 50 to match typical trade service needs

Compatibility

Designed as a standard inch-series machine screw for use in any application requiring a 10-24 UNC threaded hole with a 1/2 inch grip length under head.

Installation Notes

A Pin-In Torx driver bit of the correct size is required for installation and removal. Verify that the mating threaded hole or nut is tapped to 10-24 UNC before installation. Power down any electrical equipment before fastening hardware inside panels or enclosures, following applicable NEC guidelines. Do not overtighten stainless steel fasteners, as the material is susceptible to galling without lubrication.