Value Collection 94588 Flat Head Phillips Screw 1/4-20

Product Description

The VALUE COLLECTION 94588 is a 1/4-20 x 3/4 inch flat head Phillips machine screw manufactured from 18-8 stainless steel with a bright, uncoated finish. It features a Unified National Coarse (UNC) thread form and an overall length of 3/4 inches measured from tip to head. The flat head profile sits flush with or below the mating surface when properly countersunk, making it suitable for assemblies where a low-profile fastener is required. The 18-8 stainless steel construction provides corrosion resistance in moderate environments. This fastener is installed by machinists, maintenance technicians, electricians, and general tradespeople across a wide range of mechanical and structural applications.

This screw is used in light-duty mechanical assemblies, electrical enclosures, HVAC equipment panels, plumbing fixture brackets, and general sheet metal or machined-part fastening. The Phillips drive is compatible with standard Phillips screwdrivers and power bits. The UNC thread pitch is the most common inch-series coarse thread, making tapped holes and mating nuts widely available. This item is sold individually but subject to a minimum order quantity of 50 pieces per order.

Key Features

• 1/4-20 UNC thread for broad compatibility with standard inch-series tapped holes and nuts
• Flat head profile sits flush when installed in a countersunk hole
• Phillips drive accepts standard Phillips screwdrivers and power bits
• 18-8 stainless steel construction resists corrosion in moderate-exposure environments
• Bright uncoated finish — no plating to chip or flake
• Overall length of 3/4 inches, no washer included

Compatibility

Designed as a standard inch-series UNC machine screw suitable for use in any application requiring a 1/4-20 thread, flat head profile, and Phillips drive in stainless steel.

Installation Notes

Installation requires a properly sized countersunk hole to allow the flat head to sit flush. Use the correct Phillips bit size to avoid cam-out and head damage. Do not overtighten stainless steel fasteners, as galling can occur — apply an anti-seize compound in applications where future disassembly is expected. De-energize any electrical equipment before fastening within enclosures or panels.