Value Collection 94518 Machine Screw 6-32 X 1.5 in Ss 18-8

Product Description

The VALUE COLLECTION 94518 is a 6-32 x 1.5-inch flat head Phillips machine screw manufactured from 18-8 stainless steel with an uncoated finish. It uses a Unified National Coarse (UNC) thread standard and is sized for countersunk applications where a flush surface is required. The flat head profile seats into a countersunk hole, distributing load evenly and eliminating protrusion. This screw is a common choice for HVAC panel assembly, electrical enclosure work, plumbing fixture mounting, and light-gauge metal fabrication. The 18-8 stainless steel construction provides corrosion resistance suitable for both indoor and moderate outdoor service environments. Installation requires a Phillips driver. Overall length is measured from tip to top of head.

This screw is used across a wide range of trade applications including HVAC equipment panel fastening, electrical junction box assembly, control panel mounting, and general sheet metal or light structural work. The 6-32 thread size is standard for small machine screw applications in both residential and light commercial settings. These screws are sold in minimum quantities of 100 units per order, making them practical for contractors and service technicians who stock fasteners by the box.

Key Features

• 6-32 UNC thread for broad compatibility with standard tapped holes and hex nuts
• Flat head profile seats flush in countersunk holes, eliminating surface protrusion
• Phillips drive works with standard Phillips screwdrivers and bit drivers
• 18-8 stainless steel resists corrosion in damp or chemically active environments
• Uncoated finish with no plating that could affect dimensional tolerances in tight fits
• Overall length of 1.5 inches equals length under head, measured tip to bearing surface

Compatibility

Designed as a standard 6-32 UNC flat head Phillips machine screw suitable for use wherever a countersunk Phillips fastener of this thread size and length is specified in trade or OEM applications.

Installation Notes

Installation is performed with a Phillips screwdriver or a No. 2 Phillips bit driver. Ensure the mating hole is properly tapped to 6-32 UNC and countersunk to the correct angle before driving the screw. De-energize any electrical equipment and shut off relevant systems before accessing enclosures or panels during fastener replacement. Do not overtighten stainless steel fasteners, as the material is susceptible to galling when driven without lubrication into stainless threads.