Value Collection 94513 Flat Head Phillips Machine Screw 6-32

Product Description

The VALUE COLLECTION 94513 is a 6-32 x 5/8 inches flat head Phillips machine screw manufactured from 18-8 stainless steel with a bright, uncoated finish. It features unified national coarse (UNC) threading and an overall length of 5/8 inches measured from tip to head. The flat head profile sits flush with or below a countersunk surface, making it a standard choice for panel assembly, electrical enclosures, and light mechanical fastening. Electricians, HVAC technicians, and general trade professionals install these screws wherever a low-profile, corrosion-resistant fastener is required.

These screws are suited for use in residential and commercial applications where 6-32 UNC threading is specified. Typical installations include electrical junction boxes, control panels, equipment enclosures, and sheet metal assemblies. The 18-8 stainless steel construction provides corrosion resistance in environments with moderate moisture exposure, making them appropriate for both indoor mechanical assemblies and light outdoor or humid-area applications. Sold as a package of one unit with a minimum order quantity of 100.

Key Features

• 6-32 UNC thread for broad compatibility with standard tapped holes and hex nuts
• Flat head profile allows flush or countersunk seating in finished surfaces
• Phillips drive for use with standard #2 Phillips screwdrivers or bit drivers
• 18-8 stainless steel construction resists corrosion in moderate-moisture environments
• Bright uncoated finish with no washer — clean fit in close-tolerance assemblies

Compatibility

Designed as a standard 6-32 UNC machine screw for use in any application calling for a flat head Phillips fastener in this thread size and length.

Installation Notes

Install with a #2 Phillips screwdriver or appropriately sized bit driver. Ensure the receiving hole is tapped to 6-32 UNC or fitted with a matching nut before driving. De-energize any electrical equipment before fastening hardware to panels or enclosures. Do not overtighten stainless steel fasteners, as galling can occur — apply consistent, moderate torque until the head seats flush.