Value Collection 92230 Extended Prong Cotter Pin Ss

Product Description

The VALUE COLLECTION 92230 is an extended prong cotter pin made from 18-8 stainless steel with an uncoated finish. It measures 0.125 inches in diameter and 1.25 inches in length. The extended prong design allows the tines to be bent back securely after insertion, locking fasteners, clevis pins, and shaft components in place. This cotter pin is suited for use in corrosion-prone environments where stainless steel is preferred over carbon steel. Maintenance technicians, plumbers, HVAC service pros, and general tradespeople install this type of hardware during equipment assembly and field repairs.

This cotter pin is used in a wide range of light mechanical assemblies including linkage rods, valve stems, clevis connections, and pivot pins found in HVAC damper assemblies, pump linkages, and plumbing valve actuators. Its small diameter and stainless construction make it a practical choice for both indoor and outdoor applications where moisture or chemical exposure could cause plain steel to corrode. Sold individually, with a minimum order quantity of 50 units per order.

Key Features

• Extended prong design allows tines to bend flat for a secure, vibration-resistant lock
• 18-8 stainless steel construction resists corrosion in wet or chemically active environments
• Uncoated finish suitable for direct stainless-to-stainless contact
• 0.125-inch diameter fits standard clevis and shaft pin applications
• 1.25-inch length provides adequate tine length for most light mechanical assemblies

Compatibility

Designed as a general-purpose replacement cotter pin for light mechanical assemblies requiring a 0.125-inch diameter extended prong style fastener in stainless steel.

Installation Notes

Cotter pins are installed by tradespeople and mechanical technicians as part of fastener lockout on clevis pins, shaft ends, and linkage assemblies. De-energize and lock out any equipment before servicing pinned connections. Insert the cotter pin fully through the hole and spread the prongs apart to secure. Single-use fasteners should be replaced and never re-bent once removed.