Value Collection 91752 Brass Flat Washer 8 Screw 100 Pack

Product Description

The VALUE COLLECTION 91752 is a standard flat washer made from brass with a plain finish, sized for No. 8 screws. Flat washers distribute load across a fastened joint, reduce surface damage under bolt or nut heads, and prevent loosening from vibration. This washer measures 0.172 inches inside diameter, 7/16 inches outside diameter, and 0.036 inches thick. Brass construction offers good corrosion resistance and conductivity, making these washers a dependable choice in plumbing, electrical, and light mechanical assemblies. Each package contains 100 pieces.

These washers are suited for residential and commercial maintenance, repair, and assembly work where a No. 8 fastener is used. Common applications include plumbing fixture mounting, electrical panel work, HVAC cabinet assembly, and general mechanical fastening. Brass is a preferred material in wet or mildly corrosive environments where steel may corrode. The plain finish means no additional coating is applied, which is acceptable for most indoor and protected-outdoor installations where appearance and base-material performance are sufficient.

Key Features

• Sized for No. 8 screws with 0.172 inches inside diameter
• 7/16 inches outside diameter provides adequate load-bearing surface
• 0.036 inches thickness meets standard flat washer dimensions
• Brass material resists corrosion in damp or mildly corrosive environments
• Plain finish with no additional coating
• Sold in a 100-piece package for job-site or shop stocking

Compatibility

Designed as a standard inch-measurement flat washer for use with No. 8 screws, bolts, and nuts across plumbing, electrical, HVAC, and general mechanical fastening applications.

Installation Notes

Flat washers are installed by placing them over the fastener shank before driving the nut or bolt head against the work surface. Ensure the washer inside diameter seats cleanly over the shank without binding. Do not overtighten fasteners, as brass is softer than steel and the washer face can deform under excessive clamp load. Follow applicable codes such as NEC for electrical applications or IPC for plumbing installations when selecting fastener hardware.