Value Collection 8501-3/8A Rubber Sheet 12x12 in Black

Product Description

The VALUE COLLECTION 8501-3/8A is a black natural rubber sheet used as a raw material for gasketing, padding, vibration dampening, and general sealing applications. It measures 12 inches wide by 12 inches long with a thickness of 0.375 inches and weighs approximately 2.3 pounds. The sheet carries a Shore A durometer rating of 50 to 60 and a Shore OO rating of 55 to 65, placing it in the medium-soft hardness range. The plain backing requires no adhesive peel step, allowing the installer to cut and fit the material directly. HVAC techs, plumbers, and mechanical contractors commonly stock this type of sheet for field fabrication of custom gaskets and isolation pads.

This rubber sheet suits a wide range of residential and light commercial trade applications. It is used wherever a compressible, resilient material is needed to seal flanged connections, isolate vibrating equipment from mounting surfaces, or provide a protective wear layer. The 12 by 12 inch format allows field-cutting to virtually any profile with standard utility knives or die punches. The plain backing works with contact cement or mechanical fastening depending on the application.

Key Features

• 12 x 12 inch sheet provides enough material for multiple gasket or pad cuts from a single piece
• 0.375 inch thickness suits moderate compression and sealing applications
• Shore A durometer 50 to 60 delivers medium-soft compliance for conforming to irregular surfaces
• Plain backing allows direct bonding with contact cement or mechanical attachment
• Rated from 0 degrees F to 120 degrees F, covering most indoor mechanical room conditions
• Tensile strength of 250 psi provides resistance to tearing during cutting and installation

Compatibility

Designed as a general-purpose rubber sheet for use in HVAC, plumbing, and industrial maintenance applications requiring field-cut gaskets, isolation pads, or protective liner material.

Installation Notes

This material is typically handled by HVAC technicians, plumbers, pipefitters, and general mechanical contractors. Cut with a sharp utility knife, tin snips, or a die punch against a firm surface for clean edges. When bonding with contact cement, follow the adhesive manufacturer's surface preparation and dwell-time requirements. Confirm that the temperature and chemical environment of the application falls within the rated range of this material before installation.