Value Collection 74683939 Pan Head Phillips Machine Screw

Product Description

The VALUE COLLECTION 74683939 is a 1/4-20 x 2-inch pan head Phillips machine screw manufactured from Grade 2 steel with a Unified National Coarse (UNC) thread form. It is sold in a package of 25 pieces, making it a practical choice for volume fastening tasks. The pan head profile provides a wide, low-clearance bearing surface suited to through-hole and countersunk assemblies where a flush or low-profile finish is needed. The Phillips drive allows for fast installation with standard power or hand tools. Length is measured under the head at 2 inches. This fastener is installed by electricians, HVAC technicians, plumbers, sheet metal workers, and general tradespeople across a wide range of light-duty mechanical assemblies.

This screw is appropriate for general-purpose fastening in residential and light commercial applications. Common installation scenarios include equipment panels, junction boxes, sheet metal enclosures, electrical fixtures, HVAC component brackets, and similar assemblies where a 1/4-20 UNC thread pattern is specified. The Grade 2 steel construction is suited to non-structural, moderate-load fastening applications where corrosion resistance is not a primary requirement. No washer is included with this fastener.

Key Features

• 1/4-20 UNC thread for broad compatibility with standard tapped holes and nuts
• 2-inch length under head provides adequate grip depth for typical panel and bracket assemblies
• Pan head profile offers a wide bearing surface with low profile clearance
• Phillips drive accepts standard No. 2 Phillips bits for hand or power installation
• Grade 2 steel construction meets general-purpose fastening requirements
• Sold in a package of 25 pieces to support job-lot purchasing

Compatibility

Designed as a general-purpose replacement or stock fastener for any application requiring a 1/4-20 UNC pan head Phillips machine screw with a 2-inch length under head.

Installation Notes

Install using a No. 2 Phillips screwdriver or bit driver. Ensure the mating thread is tapped to 1/4-20 UNC specification or use a compatible hex nut and washer as required by the assembly. De-energize and lock out any electrical or mechanical equipment before accessing internal fastener locations. Do not exceed the load ratings of Grade 2 steel in structural or high-vibration applications.