Value Collection 723-5910 Roughing End Mill 2in 8-flute Cobalt

Product Description

The VALUE COLLECTION 723-5910 is a single-end roughing end mill designed for aggressive material removal in milling operations. Built from M42 cobalt high-speed steel with a bright, uncoated finish, it carries a 2-inch diameter with 8 flutes configured for right-hand cutting and right-hand flute direction. The 6-inch length of cut allows deep-reach roughing passes, while the 9-3/4-inch overall length accommodates setups requiring extended tool engagement. This tool is intended for machinists and tooling professionals running heavy roughing operations on ferrous and non-ferrous materials.

This end mill suits production and job-shop environments where high material removal rates are the priority over finish quality. Its cobalt M42 construction provides heat and wear resistance at elevated cutting speeds. The non-centercutting geometry means it is intended for peripheral milling and side-cutting applications, not plunge cutting. A 2-inch shank diameter matches standard collet and end mill holder setups used in vertical and horizontal machining centers.

Key Features

• M42 cobalt construction for elevated heat resistance and extended tool life in tough cuts
• 8-flute geometry maximizes chip load and material removal rate on roughing passes
• 6-inch length of cut supports deep-reach peripheral milling applications
• Right-hand cutting and right-hand flute direction for standard spindle operation
• Bright, uncoated finish — ready to run or accept aftermarket coating
• Non-centercutting design — optimized for side milling, not plunge entry

Compatibility

Designed for use in standard end mill holders and collet chucks accepting a 2-inch shank diameter, compatible with vertical and horizontal machining centers running right-hand spindle rotation.

Installation Notes

Installation should be performed by a qualified machinist following the machine tool manufacturer's tooling guidelines. Secure the shank fully into the holder to the recommended engagement depth before tightening. Confirm spindle rotation direction matches the right-hand cutting geometry before running. Do not use this tool for plunge cutting — the non-centercutting geometry is not designed for axial entry.