Value Collection 68025766 M10 Split Lock Washer 18-8 Ss

Product Description

The VALUE COLLECTION 68025766 is an M10 metric split lock washer manufactured from 18-8 austenitic stainless steel, Grade A2. It is designed to resist loosening caused by vibration and dynamic loads when used with M10 fasteners in bolted assemblies. The washer features an inside diameter range of 10.2 to 10.7mm and a maximum outside diameter of 18.1mm, with a thickness of 2.2mm. The spring-lock geometry bites into mating surfaces under torque to maintain clamp load. Installers working in corrosive or wet environments benefit from the stainless construction, which resists rust and oxidation without plating.

This washer is suited for use in mechanical, plumbing, electrical, and structural assemblies wherever M10 fastener corrosion resistance is a priority. Typical applications include equipment mounting, pipe hangers, panel fastening, and general fabrication in environments exposed to moisture, chemicals, or outdoor conditions. The metric sizing and multi-standard compliance make it compatible with assemblies built to ASME, ANSI, BS, DIN, JIS, and NFE specifications. It is commonly used by plumbers, electricians, HVAC technicians, and maintenance mechanics working on commercial and industrial equipment.

Key Features

• Spring-lock design resists fastener loosening under vibration and dynamic loading
• 18-8 austenitic stainless steel, Grade A2 — corrosion resistant in wet and chemical environments
• Inside diameter range: 10.2 to 10.7mm for consistent fitment on M10 fasteners
• Compliant with DIN 127B fastener standard
• Multi-standard recognized: ASME, ANSI, BS, DIN, JIS, NFE
• Metric measurement system; UNSPSC Code 31161801

Compatibility

Designed for use with M10 metric fasteners in assemblies requiring a split lock washer per DIN 127B. Fits applications built to ASME, ANSI, BS, DIN, JIS, and NFE standards.

Installation Notes

Install between the fastener head or nut and the mating surface with the split ends oriented to bite into both surfaces as the fastener is tightened. Ensure the mating fastener and surface material are compatible with stainless steel to avoid galvanic corrosion concerns. Follow applicable torque guidelines for M10 fasteners per the governing assembly specification. Do not reuse washers that have been fully compressed flat, as the locking function will be reduced.