Value Collection 67141060 Galvanized Duct End Register Boot

Product Description

The VALUE COLLECTION 67141060 is a galvanized steel end register boot designed to transition ductwork to a floor, wall, or ceiling register opening. The fitting connects a round duct to a rectangular register face, directing conditioned air into the living space. With a 6-inch inside diameter inlet and a 4-inch by 10-inch rectangular outlet, this boot suits standard residential register sizes. The galvanized steel construction resists corrosion in the damp environments common near floors and exterior walls. Licensed HVAC technicians and sheet metal installers use this fitting during new construction rough-ins and system retrofits alike.

This end register boot is suited for residential forced-air heating and cooling systems where a round branch duct terminates at a floor or wall register. The 6-inch ID inlet accepts standard 6-inch round duct, while the 4 by 10 inch face aligns with the most common residential register size. The fitting is appropriate for supply-side ductwork in light commercial applications as well, wherever a round-to-rectangular transition is needed at the point of delivery.

Key Features

• Galvanized steel construction for corrosion resistance in varied installation environments
• 6-inch inside diameter inlet accepts standard 6-inch round branch duct
• 4-inch by 10-inch rectangular outlet matches common residential register openings
• Standard gauge sheet metal suitable for typical residential and light commercial supply runs
• Overall height of 13 inches accommodates floor joist and wall cavity depth requirements

Compatibility

Designed as an OEM-style replacement or new-install fitting for residential and light commercial forced-air supply ductwork terminating at a 4-inch by 10-inch register opening with a 6-inch round duct inlet.

Installation Notes

Installation is performed by licensed HVAC technicians or qualified sheet metal installers. Shut down and lock out the air handler or furnace before cutting into existing ductwork. Secure the boot to the branch duct with sheet metal screws and seal all joints with listed duct sealant or metal-backed tape per SMACNA standards. Avoid over-driving screws through the register face flange, as this can deform the rectangular outlet and affect register seating.