Value Collection 54461 Single Jack Chain 0.062 in Steel 500 Ft

Product Description

The VALUE COLLECTION 54461 is a steel single jack chain with a nickel plated finish, sold in 1-foot increments from a 500-foot coil. Each link measures 0.062 inches in diameter with an inside length of 0.52 inches and a link density of 23 links per foot. The chain carries a working load limit of 10 pounds and is not rated for lifting applications. It is a general-purpose, lightweight chain suited for hanging, bundling, tagging, and display tasks in trade and industrial environments. Installation and maintenance personnel working in HVAC, plumbing, electrical, and general facility contexts commonly use this chain for non-structural, low-load hanging needs.

This chain is appropriate for light-duty hanging and securing applications in both residential and commercial settings. Typical uses include suspending ductwork accessories, hanging signs or tags, securing light fixtures during rough-in, and general utility tasks where a continuous-length small-diameter chain is needed. The 500-foot coil allows job-site cutting to any required length, minimizing waste. The nickel plated steel construction provides a clean finish that resists light surface corrosion in dry to mildly humid interior environments.

Key Features

• 0.062 inch wire diameter with 23 links per foot for fine-pitch, consistent chain spacing
• Inside link length of 0.52 inches suits standard hooks, fasteners, and S-links
• Nickel plated steel finish for light corrosion resistance and clean appearance
• 10-pound working load limit — appropriate for hanging and display, not lifting
• 500-foot coil priced and cut in 1-foot increments to reduce material waste

Compatibility

Designed as a general-purpose single jack chain for light-duty hanging, bundling, and display applications where a small-diameter steel chain sold by the foot is required.

Installation Notes

This chain is intended for hanging and non-structural securing tasks only and must not be used for overhead lifting of personnel or equipment. Cut to length using appropriate bolt cutters or chain cutters. Verify that all attachment hardware — hooks, fasteners, or anchors — is rated equal to or greater than the 10-pound working load limit before use. Inspect links for deformation or damage before each installation.