Value Collection 50128BBA Bent Anchor Bolt 1/2-13 8in

Product Description

The VALUE COLLECTION 50128BBA is a bent anchor bolt used to secure structural elements, equipment bases, and mechanical systems to concrete or masonry foundations. It features a 1/2-13 thread size and an 8-inch overall length (OAL), making it a standard choice for anchor bolt applications in construction and mechanical installation work. Fabricated from Grade 2 steel, it provides adequate tensile strength for general-purpose fastening tasks. Licensed contractors, ironworkers, plumbers, and HVAC mechanics commonly install this type of anchor bolt when setting equipment pads, curb frames, or structural sill plates.

This bent anchor bolt is suited for residential and light commercial applications where a J-bolt or L-bolt style anchor is required to embed in concrete footings, equipment pads, or block walls. Typical uses include securing mechanical equipment bases, water heater straps, structural sill plates, and similar anchoring tasks. The 1/2-13 thread allows for standard hex nut fastening after the bolt is cast or grouted into place.

Key Features

• 1/2-13 thread size for use with standard hex nuts and washers
• 8-inch overall length provides adequate embedment depth for most light structural anchor applications
• Grade 2 steel construction suited for general-purpose anchor bolt service
• Bent configuration allows cast-in-place anchoring in concrete or grouted masonry

Compatibility

Designed as a general-purpose replacement or new-installation anchor bolt for applications requiring a 1/2-13 threaded, bent-style anchor bolt with an 8-inch overall length in concrete or masonry substrates.

Installation Notes

Anchor bolts of this type are installed by licensed contractors, plumbers, or HVAC mechanics during equipment setting or structural rough-in. Place and align the bolt before concrete is poured or grout is applied, allowing full cure before loading the fastener. Follow applicable building codes, including IBC and IFGC requirements, for minimum embedment depth and edge distance. Do not apply structural loads until the concrete or grout has fully cured per the mix manufacturer specifications.