Value Collection 4BN1/4X8 Ss Pipe Nipple Sch 40 Npt

Product Description

The VALUE COLLECTION 4BN1/4X8 is a Schedule 40 stainless steel pipe nipple threaded to NPT standards on both ends. Pipe nipples are short threaded sections used to connect two female-threaded fittings, valves, or other piping components in a run. This nipple measures 1/4 inch nominal diameter and 8 inches in overall length, placing it in the close-to-long nipple range suitable for extending pipe runs with clearance. The stainless steel construction resists corrosion in wet, chemical-exposed, or outdoor environments. Plumbers, pipefitters, and mechanical contractors install these in process piping, plumbing supply lines, and HVAC hydronic systems where corrosion resistance is required.

This nipple is suited for residential and light commercial plumbing, industrial process lines, and HVAC hydronic or steam applications where NPT-threaded connections are standard. The 1/4 inch nominal size fits common instrumentation takeoffs, drain lines, gauge connections, and small-bore branch lines. Schedule 40 wall thickness meets typical service pressure requirements for water, steam, and compatible process fluids. A single nipple is supplied per package, making it practical for spot replacement or new construction work where individual fittings are needed.

Key Features

• Schedule 40 wall thickness for standard service pressure ratings
• NPT threads on both ends for compatibility with standard threaded fittings and valves
• Stainless steel construction for corrosion resistance in wet and chemical-exposed environments
• 1/4 inch nominal diameter fits instrumentation ports, gauge connections, and small-bore branch lines
• 8 inch length provides extension reach in tight or offset piping configurations
• Lightweight at 0.13 pounds, minimizing added load on hanging or suspended pipe runs

Compatibility

Designed as an OEM-style replacement or new-installation fitting for any system using 1/4 inch NPT-threaded Schedule 40 stainless steel pipe components.

Installation Notes

Pipe nipples of this type are installed by licensed plumbers or pipefitters following applicable IPC or ASME B31 piping codes. Always depressurize and drain the line before removing or installing threaded fittings. Apply an approved thread sealant or PTFE tape to the male NPT threads before making up the joint, and tighten to hand-tight plus the appropriate number of turns per standard practice for the pipe size. Do not over-torque stainless steel threads, as galling can damage the fitting or mating component.