Value Collection 407-1443 Fully Threaded Stud 1/4-20 2in Brass

Product Description

The VALUE COLLECTION 407-1443 is a fully threaded brass stud with a 1/4-20 unified coarse thread and an overall length of 2 inches. The entire 2-inch shaft is threaded end to end, allowing for flexible positioning of nuts and mating hardware anywhere along the stud's length. Manufactured from brass to material grade 3.6 with an uncoated plain finish, this stud delivers corrosion resistance suitable for a range of mechanical and electrical fastening applications. Licensed tradespeople and assembly technicians use fully threaded studs when a fixed anchor point or double-nut configuration is required in tight or through-hole installations.

This stud is suited for light-duty mechanical assemblies, electrical panel work, plumbing fixture mounting, HVAC component mounting brackets, and general trade applications where a 1/4-20 threaded fastener is specified. The brass construction makes it appropriate for environments where steel fasteners may corrode or where non-magnetic, low-conductivity hardware is preferred. The uncoated finish is compatible with standard hex nuts, wing nuts, and threaded inserts of matching 1/4-20 specification.

Key Features

• Fully threaded along the entire 2-inch length for maximum positioning flexibility
• 1/4-20 unified coarse thread form for broad hardware compatibility
• Brass construction with material grade 3.6 provides corrosion resistance without plating
• Uncoated plain finish — no risk of plating flake contamination in sensitive assemblies
• Minimum tensile strength of 60,000 psi per material specification
• No flat ground on shank — round cross-section for standard through-hole use

Compatibility

Designed as an OEM-style replacement or stock fastener for any application specifying a 1/4-20 fully threaded stud at 2 inches overall length in brass.

Installation Notes

Installation is performed by threading the stud into a tapped hole or securing with a jam nut on each side of the mating surface. Use a proper torque wrench or nut driver sized for 1/4-20 hardware and avoid over-torquing brass fasteners, as brass is softer than steel and susceptible to thread stripping. Ensure the receiving threads are clean and free of debris before installation. Follow applicable NEC or mechanical code requirements when using fasteners in electrical or structural applications.