Value Collection 406-040 Pvc 90 Elbow 4 in Sch 40 Slip

Product Description

The VALUE COLLECTION 406-040 is a 4-inch Schedule 40 PVC 90-degree elbow designed for use in drain, waste, vent, and general-purpose water piping systems. Built from rigid PVC, it handles typical low-pressure plumbing applications where a right-angle change of direction is needed. Both ends feature slip connections, accepting solvent-welded socket joints. The fitting weighs 2.88 pounds and conforms to Schedule 40 wall thickness standards, making it compatible with standard 4-inch PVC pipe and fittings used across residential and light commercial installations. Licensed plumbers and pipefitters are the primary installers of this type of fitting.

This elbow is suited for drain, waste, and vent lines as well as irrigation and industrial fluid-conveyance runs where PVC is the specified material. The 4-inch size addresses high-flow or large-diameter runs, common in main drain stacks, building sewers, pool plumbing return lines, and commercial irrigation manifolds. The slip-by-slip end configuration requires solvent cement and primer per local plumbing code.

Key Features

• 4-inch fitting size for high-flow drain and vent applications
• Schedule 40 wall thickness for standard-service pressure and impact ratings
• Slip x Slip end connections for solvent-cemented socket joints
• Rigid PVC construction resists corrosion and chemical attack in typical plumbing service
• 90-degree turn angle for right-angle direction changes in piping runs

Compatibility

Designed as an OEM-style replacement and new-installation fitting compatible with standard 4-inch Schedule 40 PVC piping systems using solvent-weld slip connections.

Installation Notes

Installation is performed by a licensed plumber or pipefitter following the applicable International Plumbing Code or local jurisdiction requirements. Shut off water supply and depressurize the line before cutting into any existing piping. Clean and dry all mating surfaces, apply approved PVC primer, then solvent cement before seating the fitting with a quarter-turn to distribute adhesive. Allow full cure time per the cement manufacturer before restoring flow or pressure.