Value Collection 38733 No. 10 Pan Head Sheet Metal Screw 50-pack

Product Description

The VALUE COLLECTION 38733 is a No. 10 pan head sheet metal screw designed for fastening light-gauge metal in HVAC, electrical, and general sheet metal applications. The fastener features a dual-drive slotted and Phillips recess, allowing installation with either a flathead or Phillips driver. At 1.5 inches in length under head, this Grade 2 steel screw carries a zinc-plated finish for basic corrosion resistance in dry and semi-exposed environments. The Type A and Type AB point geometry enables self-tapping entry into thin sheet metal without a pre-tapped hole. Each package contains 50 pieces.

This screw is suited for residential and light commercial sheet metal work, including ductwork assembly, electrical enclosure attachment, junction box covers, and general trade fabrication. HVAC technicians, electricians, and sheet metal workers use this fastener when assembling or securing thin-gauge metal panels and covers. The pan head profile provides a wide bearing surface and low-profile appearance on finished assemblies.

Key Features

• Dual-drive recess: accepts both slotted and Phillips drivers for installation flexibility
• Type A and Type AB self-tapping point for direct entry into sheet metal without pre-tapping
• Zinc-plated Grade 2 steel for corrosion resistance in dry and semi-exposed conditions
• Pan head geometry delivers a wide bearing surface and flush, low-profile finish
• 1.5-inch length under head suits typical light-gauge sheet metal stack-ups
• Sold in a 50-piece pack for job-site and shop use

Compatibility

Designed as a standard No. 10 self-tapping sheet metal screw for use in light-gauge steel applications typical of HVAC ductwork, electrical enclosures, and general sheet metal fabrication.

Installation Notes

Installation is performed by HVAC technicians, electricians, and sheet metal workers using a Phillips or flathead screwdriver or matching power driver bit. De-energize any electrical enclosures and shut down HVAC equipment before fastening into live assemblies. Avoid overtightening, which can strip the self-tapped thread in thin-gauge material. Follow applicable NEC or IFGC guidelines when fastening into electrical or mechanical system enclosures.