Value Collection 38558 Toggle Bolt Wall Anchor 430 Lb 50 Pack

Product Description

The VALUE COLLECTION 38558 is a steel toggle bolt anchor designed for fastening into hollow walls and similar substrates. Each anchor features a 3/16 inch diameter body and a 3 inch overall length, paired with a slotted-drive screw and a zinc finish for corrosion resistance. Rated at a maximum load capacity of 430 pounds, this toggle bolt delivers reliable holding power in demanding trade and construction applications. Licensed contractors, electricians, plumbers, and general tradespeople reach for toggle bolt anchors when solid backing is unavailable and a secure, load-bearing fastener point is required.

This anchor is suited for use in wallboard, plaster, hollow tile, and concrete or masonry substrates. It is a practical choice for residential and light commercial work where conduit hangers, fixture brackets, junction box supports, and similar hardware must be anchored to hollow or cavity wall assemblies. Each package contains 50 anchors, making it efficient for multi-point installations or repeat service calls requiring a consistent fastener on hand.

Key Features

• 430 pound maximum load capacity for secure hollow-wall fastening
• 3/16 inch diameter by 3 inch overall length for standard wall thickness applications
• Slotted drive type for compatibility with common flat-head screwdrivers
• Zinc finish provides corrosion resistance in interior environments
• Compatible with wallboard, plaster, hollow tile, and concrete or masonry
• 50 anchors per package for multi-point or high-volume installations

Compatibility

Rated for use in concrete and masonry, hollow tile, plaster, and wallboard substrates. Designed as a general-purpose toggle bolt anchor for hollow wall fastening in residential and light commercial installations.

Installation Notes

Toggle bolt anchors are typically installed by licensed electricians, plumbers, HVAC technicians, and general contractors during fixture or equipment mounting work. Always power down or de-energize any electrical circuits in the work area before drilling into walls. Drill a pilot hole sized to allow the folded toggle wings to pass through cleanly, then insert the anchor and tighten the screw until the toggle seats firmly against the back of the wall surface. Do not overtighten, as excessive torque can damage the wall substrate or deform the toggle mechanism.