Value Collection 36686 Threaded Rod 1-1/8-7 3 Ft Steel

Product Description

The VALUE COLLECTION 36686 is a full-length threaded rod machined with a 1-1/8-7 Unified National Coarse (UNC) thread form in a right-hand direction. Fabricated from low-carbon steel with a yellow zinc finish coating, this rod measures 3 feet in overall length and provides continuous threading from end to end. It is used to create tension members, hanging assemblies, anchor bolt extensions, and structural fastening connections across mechanical, plumbing, electrical, and general construction applications. Licensed tradespeople and general contractors alike rely on full-thread rod stock when a standard bolt length is insufficient for the task at hand.

This threaded rod is suited for residential and commercial applications where a long, continuously threaded fastener is required. Typical uses include pipe hangers and strut channel assemblies, equipment mounting, HVAC duct support systems, and structural tie-rod applications. The yellow zinc finish provides a baseline level of corrosion resistance for indoor or protected outdoor installations. The 1-1/8-7 UNC thread designation is compatible with standard 1-1/8 inch nuts, coupling nuts, and threaded inserts of the same thread class.

Key Features

• 1-1/8-7 UNC thread form — right-hand direction for use with standard fastening hardware
• 3-foot overall length provides continuous thread stock for cutting to any required length on site
• Low-carbon steel construction balances machinability, weldability, and tensile strength for general fastening duty
• Yellow zinc finish coating offers corrosion resistance for indoor and protected installations
• Right-hand thread direction is compatible with standard UNC nuts and threaded couplings

Compatibility

Designed for use with standard 1-1/8-7 UNC nuts, coupling nuts, threaded inserts, and rod-end hardware conforming to the Unified National Coarse thread standard.

Installation Notes

Cut to length using a reciprocating saw, angle grinder, or metal cut-off wheel, then chase the cut end with a die to restore clean thread engagement. A licensed mechanic or journeyman-level tradesperson should verify load ratings and torque requirements against applicable structural or mechanical codes before installation in a load-bearing assembly. Always de-energize and isolate any nearby electrical or mechanical systems before performing overhead or structural fastening work. Wear appropriate PPE, including eye protection, when cutting or threading rod stock.