Value Collection 33830 No 10 Self Drilling Screw 100 Pack

Product Description

The VALUE COLLECTION 33830 is a No. 10 self drilling screw designed for fast, reliable fastening in metal-to-metal and light-gauge sheet metal applications. Featuring a hex washer head with hex drive, this screw combines a built-in No. 2 drill point with a 0.625-inch length under head, allowing it to drill its own pilot hole and tap threads in a single pass. The steel construction with zinc-plated finish provides corrosion resistance in standard interior and light exterior conditions. This screw is sold in a minimum order quantity of 100 pieces, suited for bulk trade use.

This screw is commonly used in HVAC ductwork assembly, light sheet metal fabrication, electrical enclosure mounting, and general trade applications where a separate pilot hole is not practical. The hex washer head provides a broad bearing surface that resists pull-through, and the hex drive allows use with standard nut drivers and hex-bit drivers common on job sites. The No. 2 drill point is rated for use in light-gauge steel up to typical sheet metal thicknesses encountered in residential and light commercial work.

Key Features

• No. 2 drill point drills and taps in one operation, eliminating the need for a pre-drilled pilot hole
• Hex washer head delivers a wide bearing surface to resist pull-through on thin material
• Hex drive compatible with standard nut drivers and hex-bit power tools
• Steel construction with zinc-plated finish for corrosion resistance in standard service conditions
• 0.625-inch length under head suits light-gauge sheet metal fastening applications
• Sold in 100-piece minimum order quantity for efficient job-site stocking

Compatibility

Designed as a standard No. 10 hex washer head self drilling screw for use in light-gauge steel sheet metal and related trade fastening applications.

Installation Notes

Installation is typically performed by HVAC technicians, sheet metal workers, or electricians using a hex-bit driver or nut driver at controlled torque to avoid stripping the thin material. Ensure the mating material thickness is appropriate for a No. 2 drill point before driving. Do not overdrive, as the hex washer head can distort thin sheet metal or strip the fastener seat. Follow applicable trade codes and manufacturer guidelines for fastener spacing and pull-out requirements.