Value Collection 32098 Size 10 Pan Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION 32098 is a size 10 pan head sheet metal screw designed for fastening sheet metal and light-gauge materials in HVAC, electrical, and general fabrication applications. It features a Phillips drive and a Type AB point, which combines a tapered point with coarse threads for self-tapping entry into pre-punched or pre-drilled sheet metal. The screw measures 1.5 inches under the head and is manufactured from Grade 2 steel with a yellow zinc dichromate finish that provides corrosion resistance in light-duty environments. HVAC technicians, electricians, and sheet metal workers commonly use this fastener for duct assembly, equipment enclosures, and panel attachment.

This screw is suited for residential and light commercial applications where a reliable, self-tapping fastener is needed in thin-gauge steel, aluminum, or similar sheet materials. The pan head profile offers a low-profile bearing surface that sits flush against sheet metal surfaces without requiring a countersunk hole. The Phillips drive is compatible with standard power drivers and hand screwdrivers, making it practical for fast field installation. This SKU is sold individually but carries a minimum order quantity of 50 pieces per order.

Key Features

• Type AB point for self-tapping entry into pre-punched or pre-drilled sheet metal
• Pan head profile provides a broad bearing surface without requiring a countersunk opening
• Yellow zinc dichromate finish offers light corrosion resistance for indoor and protected environments
• Grade 2 steel construction provides adequate strength for light-gauge sheet metal fastening
• Phillips drive compatible with standard power drivers for fast installation
• Size 10 thread with 1.5-inch under-head length suits common duct and enclosure panel thickness

Compatibility

Designed as a standard self-tapping sheet metal screw for use in HVAC ductwork, electrical enclosures, and general sheet metal fabrication requiring a size 10 pan head Phillips fastener.

Installation Notes

Sheet metal screws of this type are installed by licensed HVAC technicians, electricians, and sheet metal workers in accordance with applicable mechanical and electrical codes. Always de-energize equipment and discharge any stored energy before fastening near electrical components. Use a pre-punched or pre-drilled pilot opening appropriate for the material gauge to avoid stripping the Type AB thread on entry. Do not overtighten, as pan head screws in light-gauge sheet metal can pull through if excessive torque is applied.