Value Collection 25961060 Galvanized Duct Register Boot 90 Degree

Product Description

The VALUE COLLECTION 25961060 is a 90-degree galvanized steel duct register boot designed to transition ductwork from a round duct to a floor, wall, or ceiling register opening. It connects the supply duct run to the register or grille in residential and light commercial forced-air HVAC systems. The boot features a 6-inch inside diameter inlet and measures 10 inches in length, 10.5 inches in width, and 8.13 inches in height. The galvanized steel construction resists corrosion in typical HVAC environments. HVAC installers and sheet metal contractors use this fitting during new construction and retrofit duct installations.

This register boot is suited for forced-air heating and cooling systems where a 90-degree offset is needed between the supply duct and the register face. The 6-inch ID inlet accommodates standard 6-inch round flex duct or rigid duct, making it a common fit for branch runs serving individual rooms in residential construction. It is also used in light commercial applications where standard register sizing applies. The 90-degree geometry allows the duct to terminate flush with a floor, sidewall, or ceiling surface depending on orientation.

Key Features

• 90-degree configuration transitions round duct to a flat register opening
• 6-inch inside diameter inlet fits standard 6-inch round duct
• Galvanized steel construction provides corrosion resistance for HVAC applications
• 10-inch overall length accommodates typical joist-bay and stud-bay installations
• Standard gauge sheet metal suitable for residential and light commercial supply runs

Compatibility

Designed as an OEM-style replacement or new-installation fitting for residential and light commercial forced-air HVAC duct systems requiring a 6-inch ID 90-degree register boot transition.

Installation Notes

Installation should be performed by a licensed HVAC technician or qualified sheet metal contractor. Shut off the air handling unit and confirm the system is de-energized before beginning ductwork modifications. Secure the boot to the duct with sheet metal screws and seal all joints with listed duct sealant or UL 181-rated tape per local mechanical code requirements. Follow applicable SMACNA standards and local mechanical codes for support spacing and joint sealing.