Value Collection 25941260 Galvanized Duct Register Boot 90 Degree

Product Description

The VALUE COLLECTION 25941260 is a 90-degree galvanized steel duct register boot designed to transition airflow from a round duct to a rectangular floor, wall, or ceiling register opening. It accepts a 4-inch inside diameter round duct on the collar end and terminates at a rectangular face sized to accept a standard register grille. At 12 inches in length, this boot provides a clean right-angle transition within the duct run. Galvanized steel construction resists corrosion in typical residential and light commercial forced-air environments. HVAC installers and sheet metal mechanics use this fitting during new construction and renovation work to complete supply or return air distribution systems.

This register boot is suited for residential and light commercial forced-air HVAC systems where a 90-degree transition is needed between a 4-inch round duct branch and a flat register opening. Common install scenarios include sub-floor supply drops, wall takeoffs, and ceiling drops where the duct must turn sharply before terminating at the finished surface. The rectangular face dimensions of 8.5 inches wide by 8 inches tall accommodate standard register grille sizes for 4-inch duct runs.

Key Features

• 90-degree offset transitions a 4-inch round duct collar to a rectangular register face
• Galvanized steel construction provides corrosion resistance in forced-air duct systems
• 12-inch overall length allows adequate depth for floor or wall installations
• 8.5-inch width by 8-inch height face opening fits standard 4-inch register grilles
• Standard gauge sheet metal suitable for residential and light commercial airflow applications

Compatibility

Designed as an OEM-style replacement or new-construction fitting for residential and light commercial forced-air HVAC supply and return duct systems using 4-inch round branch ducts.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal mechanic. Turn off the air handling unit and close the system before cutting into existing ductwork. Secure the boot collar to the round duct with sheet metal screws and seal all joints with UL-listed duct mastic or metal-backed tape per SMACNA guidelines. Do not rely on standard cloth-backed tape as a permanent air seal.