Value Collection 192-122HC Brass Angle Stop Valve Chrome

Product Description

The VALUE COLLECTION 192-122HC is a brass angle stop valve designed for residential and light commercial water supply shut-off applications. The valve features a female iron pipe (FIP) inlet connection and a 3/8-inch compression outlet, with a maximum working pressure rating of 125 psi. The body and handle are finished in chrome for a clean, corrosion-resistant appearance. Licensed plumbers and qualified tradespeople install this type of valve as part of standard rough-in and finish plumbing work, typically beneath sinks or behind toilets to isolate individual fixtures from the supply line.

This angle stop valve suits any standard water supply shut-off application where an FIP inlet connection is required. The compression outlet accommodates standard 3/8-inch supply lines commonly used with faucets, toilets, and similar fixtures. Its angle body configuration routes the supply line at 90 degrees from the wall stub-out, making it a practical choice in tight under-sink or behind-toilet installations where space is limited.

Key Features

• Brass body construction for durability and corrosion resistance in potable water service
• FIP inlet connection for direct threaded connection to wall supply stub-outs
• 3/8-inch compression outlet compatible with standard fixture supply lines
• 125 psi maximum working pressure rating suitable for residential supply systems
• Chrome finish on body and handle for a clean, finished appearance
• Angle configuration redirects flow 90 degrees from wall to fixture

Compatibility

Designed as an OEM-style replacement or new-installation angle stop valve for any water supply shut-off application requiring an FIP inlet and 3/8-inch compression outlet.

Installation Notes

Installation should be performed by a licensed plumber in accordance with local plumbing codes and the International Plumbing Code (IPC). Shut off the main water supply and relieve line pressure before removing or installing the valve. Apply thread sealant tape to all FIP threaded connections and hand-tighten before using a wrench to avoid overtightening the brass body. Verify the compression fitting is properly seated and leak-free before restoring water pressure.