Value Collection 12885 Dual Run Capacitor 35/5 Mfd 440V

Product Description

The VALUE COLLECTION 12885 is a dual run capacitor rated at 35/5 microfarads (MFD) and 440 volts, designed for use in single-phase HVAC motor circuits. Dual run capacitors serve two motor loads simultaneously, typically supporting both the compressor and the condenser fan motor from a single component. Standing 4.75 inches tall, this capacitor fits standard oval or round mounting configurations found in residential and light commercial condensing units. Licensed HVAC technicians replace these components when a system exhibits hard-start symptoms, motor hum without rotation, or fails a capacitor test with a digital multimeter. The unit weighs 0.95 pounds.

This capacitor is suited for use in air conditioning condensing units and heat pump outdoor sections where a single capacitor serves both the compressor and fan motor windings. It is a common replacement item during seasonal startups, compressor failure diagnostics, and routine preventive maintenance calls on split-system equipment. The 440-volt rating makes it compatible with standard 208/230-volt single-phase motor applications and provides a safe voltage margin above typical operating conditions.

Key Features

• Dual run design handles compressor and condenser fan motor from one component
• 35/5 MFD rating covers both motor windings in a single capacitor body
• 440-volt rating provides safe operating margin for 208/230-volt single-phase circuits
• Compact 4.75-inch height fits standard condensing unit capacitor brackets
• Lightweight at 0.95 pounds for easy single-tech handling during service calls

Compatibility

Designed as an OEM-style replacement dual run capacitor for residential and light commercial single-phase air conditioning and heat pump condensing units requiring a 35/5 MFD, 440-volt rated component.

Installation Notes

Installation should be performed by a licensed HVAC technician following local codes and equipment manufacturer guidelines. Always disconnect and lock out power to the unit before handling capacitors, and discharge the capacitor fully using an approved discharge tool or resistor before removal. Verify the replacement MFD ratings and voltage rating match the original component before installation. Capacitor terminals carry lethal stored charge even when the unit is powered off.