Value Collection 115AB15060 Pressure Gauge 60 Psi

Product Description

The VALUE COLLECTION 115AB15060 is a liquid-filled analog pressure gauge designed for accurate pressure monitoring in plumbing, HVAC, and light industrial service applications. The gauge features a 1.5-inch stainless steel case with brass wetted parts and a bronze Bourdon tube. Glycerine and water fill dampens needle vibration and extends service life in moderate-pulsation environments. Accuracy is rated at plus or minus 3-2-3 percent of scale across a 0 to 60 psi range, meeting standard commercial instrumentation tolerances. The center back mount configuration suits panel and manifold installations where a flush, rear-entry connection is required.

This gauge is suited for residential and light commercial plumbing systems, hydronic heating circuits, compressed air lines, and HVAC equipment where low-pressure monitoring up to 60 psi is needed. The 1/8-inch NPT center back connection makes it compatible with standard threaded taps found on pipe manifolds, pump bodies, and equipment ports. Plumbers, HVAC technicians, and mechanical contractors typically install this type of gauge as a permanent monitoring point or a service diagnostic fitting.

Key Features

• 0 to 60 psi pressure range with plus or minus 3-2-3 percent of scale accuracy
• Liquid filled with glycerine and water for vibration and pulsation dampening
• 1.5-inch analog dial for easy at-a-glance reading in tight spaces
• Stainless steel case resists corrosion in wet or outdoor environments
• Brass wetted parts and bronze Bourdon tube for compatibility with water and air service
• 1/8-inch NPT center back mount fits standard threaded gauge ports

Compatibility

Designed as a standard replacement or new-installation pressure gauge for plumbing, hydronic, HVAC, and compressed air systems with 1/8-inch NPT gauge ports rated within the 0 to 60 psi operating range.

Installation Notes

Installation should be performed by a licensed plumber or qualified mechanical technician. Isolate and depressurize the system completely before removing any existing gauge or fitting the new gauge into the port. Apply thread sealant or PTFE tape to the NPT threads in accordance with local plumbing code requirements. Do not overtighten the gauge body; use the wrench flats on the connection fitting only, and avoid torquing through the case.