Value Collection 111CB25100 Pressure Gauge 100 Psi

Product Description

The VALUE COLLECTION 111CB25100 is an analog pressure gauge designed for monitoring system pressure in plumbing, HVAC, and general industrial applications. It features a 2.5-inch dial with a 0 to 100 psi range and an accuracy rating of plus or minus 3-2-3 percent of scale. The ABS case houses brass wetted parts and a bronze Bourdon tube, making it suitable for use with water, air, and other compatible media. Installation is straightforward via the 1/4-inch NPT center back mount connection. Licensed plumbers, HVAC technicians, and mechanical contractors install this gauge during system commissioning or as a replacement in existing pressure monitoring points.

This gauge fits residential and light commercial systems where a compact, dry-fill analog gauge is required at a panel, manifold, pump discharge, or pressure test port. The center back mount configuration allows it to sit flush against a panel or wall-mount bracket. The 2.5-inch dial provides clear readability at close range without liquid fill, keeping installation simple and cost-effective. No compatible model numbers or system family names were specified in the product data.

Key Features

• 0 to 100 psi pressure range with plus or minus 3-2-3 percent of scale accuracy
• 2.5-inch analog dial for clear, direct reading
• 1/4-inch NPT center back mount connection for panel or manifold installation
• Brass wetted parts and bronze Bourdon tube for compatibility with water and air service
• ABS case construction — lightweight and corrosion-resistant
• Dry-fill (non-liquid-filled) design simplifies installation and replacement

Compatibility

Designed as a standard replacement or new-installation analog pressure gauge for residential and light commercial plumbing, HVAC, and compressed air systems using 1/4-inch NPT back-mount connections.

Installation Notes

Installation should be performed by a licensed plumber or qualified mechanical technician. Depressurize and isolate the system before removing any existing gauge or fitting. Apply thread sealant tape or pipe compound to the NPT threads per IPC guidelines and tighten to hand-tight plus a moderate wrench turn — do not overtighten the ABS case. After installation, slowly repressurize the system and inspect for leaks before returning to service.