Value Collection 0810KPP No 8 Self Drilling Screw 5/8 in

Product Description

The VALUE COLLECTION 0810KPP is a No. 8 self-drilling screw designed for fast, clean fastening without a pre-drilled pilot hole. The pan head profile sits flush against the work surface, while the Phillips drive provides positive engagement with standard power drivers. At 5/8 inch length under head with a No. 2 drill point, this screw is sized for light-gauge metal-to-metal and metal-to-substrate assembly. The 1016/1024 steel body with zinc-plated finish offers corrosion resistance in typical indoor and light-exposure applications. Sold in a minimum order quantity of 100 pieces.

This screw is commonly used in HVAC duct fabrication, electrical enclosure assembly, light structural metal framing, and general sheet metal work. The No. 2 drill point is matched to thin-gauge steel sheet, making it a practical choice for attaching sheet metal panels, junction boxes, and similar components where speed and efficiency matter on the job. The pan head and Phillips drive combination is compatible with standard No. 2 Phillips bits used by HVAC technicians, electricians, and general trade contractors.

Key Features

• No. 8 screw size with No. 2 drill point for light-gauge sheet metal applications
• Pan head profile provides a low-profile, broad bearing surface
• Phillips drive for compatibility with standard No. 2 Phillips power bits
• 1016/1024 steel construction meets AISI 1016, ASME B18.6.3, ASME B18.6.4, and SAE J78 standards
• Zinc-plated finish for corrosion resistance in indoor and light-exposure environments
• 5/8 inch length under head suited for thin-gauge metal fastening

Compatibility

Designed as a standard No. 8 self-drilling pan head screw for light-gauge metal-to-metal and metal-to-substrate fastening applications in HVAC, electrical, and general sheet metal work.

Installation Notes

Self-drilling screws do not require a pilot hole in compatible light-gauge material — allow the drill point to do the work before applying full driving torque. Use a No. 2 Phillips bit and a variable-speed driver to avoid cam-out or overdriving the head. Power down all equipment and de-energize panels before fastening near live electrical or HVAC components. Follow applicable codes including NEC and SMACNA guidelines for fastener placement and spacing in duct and enclosure work.