Value Collection 03584042 Diamond Cutoff Wheel 8in

Product Description

The VALUE COLLECTION 03584042 is a Type 1A1R diamond cutoff wheel designed for precision cutting applications in abrasive and hard-material work. Measuring 8 inches in diameter with a 0.045-inch kerf thickness and a 1-1/4-inch arbor hole, this wheel uses a 120-grit diamond abrasive bonded in a resinoid matrix. The 1/4-inch superabrasive depth and 100 concentration rating indicate a fully loaded cutting edge suited for consistent performance across the wheel's usable life. It is a single-piece wheel intended for use with circular saws in shop or field cutting scenarios.

This cutoff wheel is used in applications requiring clean, controlled cuts through hard or abrasive materials. The Type 1A1R straight wheel profile fits standard circular saw arbors with a 1-1/4-inch bore. It is a common choice for trade professionals and fabricators who need a reliable diamond wheel for tile, masonry, concrete, or similar materials in both residential and light commercial work environments.

Key Features

• 120-grit diamond abrasive for controlled cutting through hard materials
• Resinoid bond provides consistent cutting action and wheel integrity under load
• Type 1A1R straight wheel profile for use with standard circular saws
• 0.045-inch kerf thickness minimizes material loss per cut
• 1/4-inch superabrasive depth with 100 concentration rating for extended wheel life
• 1-1/4-inch arbor hole fits common circular saw spindles

Compatibility

Designed for use with circular saws equipped with a 1-1/4-inch arbor. Verify that your saw's rated RPM meets or exceeds the maximum RPM marked on the wheel before mounting.

Installation Notes

Installation should be performed by a qualified operator familiar with abrasive wheel safety per ANSI B7.1 guidelines. Always power down and disconnect the saw before mounting or removing the wheel. Inspect the wheel for cracks or chips before each use and never exceed the maximum operating RPM rating. Use the appropriate flanges and blotters as required by the tool manufacturer.