Value Collection 0212100 Pipe Nipple 1-1/4 in 10 in Sch 40

Product Description

The VALUE COLLECTION 0212100 is a galvanized steel pipe nipple used to connect threaded pipe sections in water supply, gas distribution, and general plumbing systems. Sized at 1-1/4 inches nominal pipe size and 10 inches in length, it is manufactured to Schedule 40 wall thickness standards and threaded on both ends for direct engagement with couplings, fittings, or valves. The galvanized zinc coating provides corrosion resistance in wet or exposed environments. This nipple is a standard close-to-long-length fitting installed by licensed plumbers and pipefitters in both residential and light commercial applications.

This nipple suits residential water supply lines, commercial plumbing rough-in, irrigation system headers, and low-pressure gas piping where 1-1/4-inch Schedule 40 galvanized steel fittings are specified. It is compatible with standard NPT threaded fittings and couplings of the same nominal pipe size. At 1.696 pounds, it is a mid-weight nipple appropriate for above-ground and below-slab installations where the applicable plumbing code permits galvanized steel pipe.

Key Features

• 1-1/4 inch nominal pipe size with Schedule 40 wall thickness for pressure-rated service
• 10 inches overall length for moderate-span pipe connections
• Threaded on both ends using standard NPT thread form
• Galvanized steel construction resists corrosion in wet and damp installations
• Weighs 1.696 pounds — suitable for standard pipe hanger and support spacing

Compatibility

Designed as a standard NPT-threaded replacement or new-installation nipple compatible with 1-1/4 inch Schedule 40 galvanized steel pipe systems and standard NPT couplings, unions, and fittings of matching nominal pipe size.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable IPC or local plumbing code requirements. Apply an approved pipe thread sealant or PTFE tape to the male threads before make-up. Hand-tighten first, then use a pipe wrench to achieve full thread engagement without overtightening. Shut off and depressurize the supply line before cutting in or replacing any threaded nipple in a live system.