Value Collection 0208ABPP No. 2 Pan Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION 0208ABPP is a No. 2 pan head sheet metal screw designed for fastening light-gauge sheet metal, thin plastics, and similar materials in trade and fabrication applications. It features a Phillips drive with a No. 1 driver size, a Type AB point for self-starting penetration, and a zinc-plated finish for basic corrosion resistance. The screw measures 1/2 inch in length under head and is produced from Grade 1016-1024 steel. HVAC technicians, electricians, and sheet metal workers commonly use fasteners in this size range for securing ductwork panels, junction box covers, and sheet metal enclosures.

This fastener is suited for residential and light commercial applications where a small-diameter, short-length screw is required. It is a standard inch-measurement fastener compliant with ASME B18.6.3, ASME B18.6.4, AISI 1016, and SAE J933, making it appropriate for work that must meet recognized dimensional and material standards. It is sold in a package quantity of one unit with a minimum order quantity of 100 units, making it practical for shop stock and service van inventory.

Key Features

• Type AB point for self-starting entry into light-gauge sheet metal without pre-drilling
• Pan head profile distributes clamping load and sits flush against flat surfaces
• No. 1 Phillips drive for compatibility with standard power and hand drivers
• Zinc-plated Grade 1016-1024 steel construction for strength and basic corrosion protection
• Compliant with ASME B18.6.3, ASME B18.6.4, AISI 1016, and SAE J933 standards

Compatibility

Designed as a standard No. 2 Type AB pan head sheet metal screw for use in light-gauge sheet metal, thin thermoplastics, and similar substrates common in HVAC, electrical, and general sheet metal fabrication work.

Installation Notes

Sheet metal screws in this size are typically installed by HVAC technicians, electricians, or sheet metal workers using a No. 1 Phillips bit with a power driver or hand screwdriver. Confirm the substrate thickness is appropriate for a 1/2-inch length-under-head fastener before driving. Avoid overdriving, as the thin material can strip or deform around the screw head. Minimum order quantity requirements apply — order in multiples of 100.