Value Collection 01408467 Taper Length Drill Bit Hss

Product Description

The VALUE COLLECTION 01408467 is a taper length twist drill bit ground from high-speed steel (HSS) with a black oxide finish. It measures 0.0810 inches in diameter, equivalent to a Number 46 wire gauge size, and carries a standard 118-degree split point angle with web thinning for improved centering on entry. The overall length is 4.25 inches with a flute length of 2.25 inches, giving it greater reach than a jobber-length bit. The straight-cylindrical shank seats securely in standard drill chucks. Right-hand spiral flutes clear chips efficiently during through-hole drilling operations.

This drill bit is suited for general-purpose metalworking, light fabrication, and maintenance applications where a small-diameter hole at extended depth is required. The taper length configuration makes it appropriate for drilling into recessed areas or through thicker stock where a jobber-length bit would fall short. It is commonly used by machinists, maintenance technicians, pipefitters, and HVAC or plumbing installers drilling pilot or tap-prep holes in ferrous and non-ferrous metals.

Key Features

• 0.0810 inch diameter, Number 46 wire gauge size
• HSS construction with black oxide finish for corrosion and heat resistance
• 118-degree standard point angle with web thinning for accurate entry
• Taper length body at 4.25 inches overall for extended reach
• Right-hand spiral flutes promote efficient chip evacuation
• Straight-cylindrical shank fits standard 3-jaw and keyless drill chucks

Compatibility

Designed as a general-purpose taper length drill bit compatible with any standard drill press, hand drill, or mill with a chuck capacity accepting a straight-cylindrical shank at 0.0810 inch diameter.

Installation Notes

This bit is installed and removed by a licensed machinist or qualified tradesperson using a standard drill chuck key or keyless chuck. Always secure the workpiece before drilling and operate at a spindle speed appropriate for the material and bit diameter. Inspect the cutting edges before each use and replace if chipped or dull to avoid workpiece damage or bit breakage. Cutting fluid is recommended when drilling ferrous metals to extend tool life.