Usa Industrials BULK-RS-SBRFR75-5 Sbr Rubber Sheet Roll

Product Description

The USA INDUSTRIALS BULK-RS-SBRFR75-5 is a polyester-reinforced styrene butadiene rubber (SBR) sheet roll designed for industrial sealing, gasketing, and lining applications. Measuring 36 inches wide and available in stock lengths, this roll delivers a Shore A durometer rating of 70 to 80, placing it firmly in the medium-hard range suitable for applications requiring good abrasion resistance and structural integrity. The polyester reinforcement adds dimensional stability and tear resistance beyond what unreinforced SBR sheet provides. Weighing 1.5 pounds per packaged unit, it is handled and cut to length by maintenance technicians, fabricators, and mechanical contractors.

This SBR sheet roll is suited for use in industrial, commercial, and light mechanical environments where moderate chemical resistance and broad temperature tolerance are needed. Typical applications include fabricating custom gaskets, protective liners, conveyor components, and vibration-damping pads. The black color and reinforced construction make it a practical choice for outdoor or high-wear service points. It performs across a temperature range of -20 degrees F to 170 degrees F, covering most non-extreme HVAC, plumbing, and industrial service conditions.

Key Features

• Polyester-reinforced SBR construction for improved tear resistance and dimensional stability
• Shore A durometer of 70 to 80 for medium-hard, abrasion-resistant performance
• 36-inch width accommodates wide-format gasket and liner fabrication without splicing
• Temperature range of -20 degrees F to 170 degrees F suits most mechanical service environments
• Tensile strength of 800 psi provides reliable performance under compression and shear loads
• Stock-length roll format allows on-site cutting to exact dimensions

Compatibility

Designed as a general-purpose industrial rubber sheet material for use wherever polyester-reinforced SBR sheet is specified for gasketing, lining, or sealing fabrication.

Installation Notes

Cutting should be performed by a qualified fabricator or maintenance technician using a straight edge and utility knife or die cutter. Ensure all mating surfaces are clean and free of debris before installing fabricated gaskets or liners. Follow applicable mechanical and safety codes when integrating custom-cut sheet into pressurized or load-bearing assemblies. Do not expose this material to temperatures, chemicals, or pressures outside the stated specifications.