Usa Industrials BULK-RS-N60TXT-35 Neoprene Sheet Roll 36in

Product Description

The USA INDUSTRIALS BULK-RS-N60TXT-35 is a neoprene rubber sheet roll cut to stock length, 36 inches wide and 0.187 inches thick, with a textured finish and plain backing. It carries a Shore A durometer rating of 50 to 60, placing it in the medium-firm range suitable for gasketing, sealing, vibration damping, and general-purpose fabrication work. The material handles temperatures from -20 degrees F to 180 degrees F and has a tensile strength of 1000 psi. Plumbers, HVAC technicians, industrial maintenance techs, and fabricators work with this material regularly when cutting custom gaskets, pads, or weather seals on the job or in the shop.

This neoprene sheet roll is suited for both light commercial and industrial applications where a durable, oil-resistant elastomer is needed. Common uses include pipe flange gaskets, equipment vibration isolation pads, HVAC duct seals, and general sealing applications. The 36-inch width allows for efficient cutting of larger gaskets or multiple smaller pieces with minimal waste. The textured surface aids in grip and adhesion in layered assemblies. Plain backing means no adhesive is pre-applied, giving the installer full control over bonding method.

Key Features

• Neoprene rubber construction with medium-firm 50 to 60 Shore A durometer for gasketing and sealing use
• Textured finish for improved grip and surface adhesion in assemblies
• 0.187-inch thickness suitable for standard flange and sealing applications
• Temperature range of -20 degrees F to 180 degrees F for broad service conditions
• Tensile strength of 1000 psi for reliable performance under compression and load
• Plain backing allows installer-chosen bonding method

Compatibility

Designed as a general-purpose neoprene sheet roll for custom-cut gasketing, sealing, and vibration isolation in HVAC, plumbing, and industrial maintenance applications.

Installation Notes

Cutting should be performed with a sharp utility knife, die cutter, or scissors on a flat, clean surface to ensure clean edges. Power down or depressurize any system before removing an existing gasket or seal and installing a new one cut from this material. When bonding to metal or other substrates, use a contact adhesive rated for neoprene and follow the adhesive manufacturer's cure time before returning the assembly to service. Follow applicable codes and manufacturer guidelines for the system being serviced.