Usa Industrials BULK-RS-EN50-2 Neoprene Sheet 12x12

Product Description

The USA INDUSTRIALS BULK-RS-EN50-2 is a stock-length neoprene rubber sheet cut to 12 inches wide by 12 inches long, finished in black. It carries a Shore A durometer rating of 45 to 55, placing it in the medium-soft range suitable for gaskets, isolators, seals, and vibration pads. The sheet handles a working temperature range of -20 degrees F to 220 degrees F and a tensile strength of 800 psi, making it a practical general-purpose elastomer for HVAC, plumbing, and mechanical service applications. Licensed tradespeople and maintenance technicians cut and fit it on the job to replace worn isolation mounts, flange gaskets, and pipe support pads.

This neoprene sheet is suited for both residential and light commercial applications. Common uses include fabricating custom gaskets, anti-vibration pads under equipment feet, pipe saddle liners, and weather seals. HVAC technicians use neoprene sheet stock to isolate compressors and air handler components. Plumbers cut sections for flange face seals and soft-jaw pipe vise liners. The 12 x 12 inch format provides enough material for most single-component fabrication tasks without waste.

Key Features

• Shore A durometer of 45 to 55 for medium-soft compressibility and conformability
• Temperature rated from -20 degrees F to 220 degrees F for broad service range
• Tensile strength of 800 psi provides resistance to tearing during cutting and installation
• 12 x 12 inch stock format allows on-site cutting to any required shape
• Black neoprene construction resists oils, weathering, and ozone exposure common in mechanical rooms

Compatibility

Designed as a general-purpose neoprene sheet for fabricating gaskets, isolation pads, and seals in HVAC, plumbing, and mechanical service applications where a medium-soft elastomer with moderate temperature resistance is required.

Installation Notes

Cut to shape using a sharp utility knife or die-cut punch on a firm, flat surface. De-energize or shut off equipment before replacing any gasket or isolation mount. Follow applicable mechanical and plumbing codes when using sheet stock as a flange gasket or pipe support material, as some jurisdictions specify minimum gasket material ratings. Inspect mating surfaces for debris or damage before seating the cut piece.