Usa Industrials BULK-RS-BHS70-239 Buna-n Sheet Roll

Product Description

The USA INDUSTRIALS BULK-RS-BHS70-239 is a Buna-N (nitrile) rubber sheet roll used in industrial gasketing, sealing, and fabrication applications. It measures 0.25 inches thick and 36 inches wide, with a Shore A durometer rating of 65 to 75, placing it in the medium-firm hardness range suited for cut-to-fit gaskets and vibration isolation pads. Buna-N compound provides solid resistance to petroleum-based oils, fuels, and many common hydraulic fluids. The sheet is black and supplied in stock lengths. HVAC technicians, plumbers, pipefitters, and industrial maintenance crews routinely use this material to fabricate custom gaskets and seals on the job.

This rubber sheet roll is appropriate for a wide range of trade and light industrial uses including equipment isolation mounts, pipe flange gaskets, compressor pads, and general sealing applications. It performs across a service temperature range of -40 degrees F to 212 degrees F, making it suitable for both refrigeration-adjacent and moderate-heat plumbing and mechanical system applications. The roll format allows field techs to cut pieces to the exact dimensions required for the task at hand, reducing material waste and eliminating the need to stock multiple pre-cut sizes.

Key Features

• Buna-N (nitrile) rubber construction with resistance to oils, fuels, and hydraulic fluids
• Shore A durometer of 65 to 75 for medium-firm, cut-to-fit sealing applications
• Tensile strength rated at 1500 psi for durable gasket and seal fabrication
• Wide service temperature range: -40 degrees F to 212 degrees F
• 36-inch width accommodates large-format cuts and custom gasket shapes
• Black stock-length roll format for flexible, on-site fabrication

Compatibility

Designed as a general-purpose Buna-N rubber sheeting material suitable for fabricating gaskets, seals, and isolation pads in HVAC, plumbing, and industrial mechanical applications where oil and fuel resistance is required.

Installation Notes

Cut this sheet using a utility knife, die cutter, or hole saw on a clean, flat surface. Power down or depressurize any system before removing an existing gasket or seal and installing a replacement cut from this material. Verify chemical compatibility with the specific fluids or gases present in the system before installation. Consult applicable mechanical or plumbing codes when using field-fabricated gaskets in pressurized or regulated systems.