Tritan 607 Zz Prx Deep Groove Ball Bearing 19mm Double Shield

Product Description

The TRITAN 607 ZZ PRX is a deep groove ball bearing designed for light-duty rotational applications across HVAC, refrigeration, and general mechanical equipment. It features a 19 mm outside diameter with a double-shield closure that retains grease or oil lubrication and blocks contaminant ingress. The single-row ball configuration handles radial loads in a compact footprint. A static load capacity of 205 pounds makes it suitable for lower-speed, steady-state load conditions. The steel cage and steel ball material deliver consistent performance in standard operating environments. This bearing is installed by HVAC technicians, refrigeration mechanics, and general equipment service professionals.

This bearing fits applications where a 600-series, 7 mm bore deep groove ball bearing is required. Common install scenarios include small electric motor shafts, blower wheel hubs, fan assemblies, and light mechanical drives found in residential and light commercial HVAC equipment. The double-shield design suits enclosed environments where periodic relubrication access is limited. The round bore and standard 600-series dimensions allow drop-in replacement in any application calling for a 607-series bearing.

Key Features

• Double-shield closure retains grease or oil and resists contamination without requiring seals
• Steel ball and steel cage construction for standard load and temperature environments
• Single-row deep groove design accommodates radial loads in a compact package
• 205-pound static load capacity rated for steady-state and low-speed applications
• 600-series dimensions for broad interchangeability across common equipment platforms
• ABEC-1 tolerance rating appropriate for general-purpose mechanical applications

Compatibility

Designed as a direct replacement for any application requiring a 607-series deep groove ball bearing with a double-shield closure and standard 600-series dimensions.

Installation Notes

Installation is performed by qualified HVAC technicians, refrigeration mechanics, or mechanical service professionals. Disconnect and lock out all power to the equipment before removing the old bearing. Use a proper bearing press or driver tool to seat the bearing squarely on the shaft and into the housing bore - never strike the bearing directly with a hammer. Verify shaft and housing tolerances before installation to avoid premature failure from misfit.