Tritan 605 Zz Prx Deep Groove Ball Bearing 14mm Double Shield

Product Description

The TRITAN 605 ZZ PRX is a deep groove ball bearing designed for light-duty rotational applications where reliable radial load support and contaminant exclusion are required. It features a double-shield closure that retains grease or oil lubrication while blocking dust and debris from reaching the rolling elements. The bearing carries a static load capacity of 115 pounds and is built with steel balls and a steel cage in a single-row configuration. It is rated ABEC-1 and belongs to the 600 series. Licensed HVAC technicians, motor repair shops, and mechanical service professionals install this bearing type in small motors, fans, pumps, and similar rotating equipment.

This bearing fits rotating equipment with shaft and housing dimensions matching the 600 series standard. The 14 mm outside diameter and round bore make it a direct fit for small fractional-horsepower motors, blower assemblies, and pump shafts common in residential and light commercial mechanical systems. The double-shield design suits environments where periodic lubrication access is not practical, since the grease charge is retained at the factory. No snap ring is included with this bearing.

Key Features

• Double-shield closure retains lubricant and excludes contaminants without full contact-seal drag
• Steel ball and steel cage construction for consistent performance in standard service conditions
• 115 pounds static load capacity for light-duty radial load applications
• Single-row, round bore configuration for straightforward shaft installation
• Compatible with grease or oil lubrication depending on application requirements
• ABEC-1 tolerance class suits general mechanical service where precision tolerances are not critical

Compatibility

Designed as an OEM-style replacement for 600 series deep groove ball bearings with a 14 mm outside diameter and double-shield closure in small motor and rotating equipment applications.

Installation Notes

Installation should be performed by qualified mechanical or HVAC service technicians. De-energize and lock out the equipment before removing or installing any bearing. Press force should be applied to the bearing ring that matches the interference-fit surface - never drive force through the balls or shields. Refer to equipment manufacturer documentation for shaft and housing tolerances before installation.