Tigre Usa Inc 1401-007 3/4 Inch Poly Insert Tee

Product Description

The TIGRE USA INC 1401-007 is a 3/4-inch barbed insert tee fitting designed for use with polyethylene (PE) pipe in cold water distribution systems. Configured as Poly x Poly x Poly, this fitting allows a single supply line to branch into two outlets using standard barbed insert connections secured with stainless steel clamps. Rated and listed under ASTM D-2609, NSF 14, and NSF 16, the 1401-007 is approved for potable water service. Plumbers and irrigation contractors install this fitting where PE pipe runs require a tee junction in residential irrigation, rural water lines, or similar cold water applications.

This fitting is intended strictly for cold water service in non-dwelling applications such as outdoor irrigation systems, agricultural water lines, and similar low-pressure cold water distribution. It is not rated for use with compressed air or gases, and it must not be installed inside a dwelling. The barbed insert design seats firmly inside the PE pipe bore, and a stainless steel clamp is applied over each barb connection to maintain a secure, leak-resistant joint.

Key Features

• 3/4-inch barbed Poly x Poly x Poly tee configuration for three-way PE pipe branch connections
• ASTM D-2609 listed — meets dimensional and performance standards for plastic insert fittings
• NSF 14 and NSF 16 listed for potable water service
• Compatible with stainless steel clamp installation — no solvent, heat, or threading required
• Cold water use only — not rated for compressed air, gases, or interior dwelling installation
• Sold as individual unit; supplier package quantity of 25 units per package

Compatibility

Designed for use with 3/4-inch polyethylene (PE) pipe secured with stainless steel insert clamps. Suitable for cold water potable water service lines in non-dwelling applications per ASTM D-2609, NSF 14, and NSF 16 listing requirements.

Installation Notes

Installation is performed by plumbers or irrigation contractors working on PE pipe cold water systems. Before servicing, shut off the water supply and relieve line pressure completely. Each barbed end must be fully inserted into the PE pipe bore and secured with a stainless steel clamp — fitting modifications of any kind void the manufacturer warranty. Do not use this fitting with compressed air, gases, or in any interior dwelling application.

Technical Specifications

• Size: 3/4 inch
• Connection Type: Barbed Insert (Poly x Poly x Poly)
• Pipe Material Compatibility: Polyethylene (PE)
• Service: Cold water only
• Certifications: ASTM D-2609, NSF 14, NSF 16
• Weight: 2.1 pounds
• Package Quantity: 25 per package

Standard Information

• Brand: TIGRE USA INC
• Manufacturer Part Number: 1401-007