Thomas Betts WT2-TB Cable Tie Installation Tool

Product Description

The THOMAS BETTS WT2-TB is a manual-actuation cable tie installation tool designed for use with nylon cable ties ranging from 0.184 to 0.301 inches in width and rated for 50 to 120 pounds of tensile strength. Built from plastic construction, this hand tool applies consistent tension to cable ties and automatically cuts the tail at a flush, controlled length. Electricians and low-voltage installers use this tool to speed up wire bundling tasks and achieve repeatable tie tension without over-stressing the tie or the bundle. It is RoHS compliant, making it suitable for use in environmentally regulated installations.

This tool is suited for residential and commercial electrical work, panel wiring, conduit bundling, and general wire management tasks. Any application where nylon cable ties are used for wire harnessing, tray bundling, or securing components to supports benefits from a dedicated installation tool over hand-tightening. The WT2-TB is particularly useful on jobs that require a high volume of cable ties, where consistent tension and a clean cut on every tie reduces rework and improves the finished appearance of the installation.

Key Features

• Manual actuation requires no power source or compressed air
• Compatible with nylon cable ties 0.184 to 0.301 inches wide
• Handles cable ties with tensile strength ratings from 50 to 120 pounds
• Plastic tool body reduces overall weight for extended use
• RoHS compliant construction for use in regulated environments

Compatibility

Designed for use with nylon cable ties in the 0.184 to 0.301 inch width range with tensile strength ratings between 50 and 120 pounds, consistent with standard electrical and low-voltage cable tie specifications.

Installation Notes

This tool is typically used by licensed electricians and low-voltage technicians during wire management and bundling work. No power source is required. Before use, confirm the cable tie width and tensile strength fall within the tool's rated range to avoid tool damage or incomplete cuts. Follow applicable NEC guidelines when bundling conductors in panels, raceways, or cable trays.