Telemecanique Sensors XCSDMC5902 Safety Limit Switch

Product Description

The TELEMECANIQUE SENSORS XCSDMC5902 is a noncontact safety limit switch designed for machine guarding and safety interlock applications. It operates at 24 volts DC and is rated for 100 amps, with a 2NO/2NC contact configuration that provides both normally open and normally closed outputs in a single device. The plastic housing measures 16 millimeters wide, 7 millimeters deep, and 51 millimeters high, making it a compact solution for tight mounting locations. A 2-meter cable provides the termination connection. Licensed electricians and machine safety technicians are the primary installers of this switch.

This switch is suited for industrial machine safety circuits, guarded access points, and automated equipment where noncontact sensing is required to monitor door or guard position. Its IP66 and IP67 ingress protection ratings make it appropriate for wash-down environments, outdoor enclosures, and areas exposed to dust or water intrusion. The 2NO/2NC configuration supports redundant safety circuit architectures commonly required under machine safety standards.

Key Features

• Noncontact sensing eliminates mechanical wear on the actuator interface
• 2NO/2NC contact configuration supports redundant safety loop wiring
• 24 VDC operating voltage compatible with standard safety relay and controller inputs
• IP66 and IP67 rated for dust-tight and water-immersion resistance
• 2-meter cable termination for flexible routing without additional connectors
• Compact plastic body at 16 millimeters wide x 7 millimeters deep x 51 millimeters high

Compatibility

Designed as an OEM-style replacement or new-installation noncontact safety limit switch for industrial machine guarding and safety interlock systems requiring 24 VDC operation and a 2NO/2NC output configuration.

Installation Notes

Installation should be performed by a qualified electrician or machine safety technician in accordance with NEC requirements and applicable machine safety standards. Disconnect and lock out all power to the machine before mounting or wiring this switch. Verify that the noncontact actuator and switch head are aligned within the manufacturer-specified sensing distance before applying power. Do not exceed the rated voltage or current values for the contact outputs.