Superior Essex PW52-H46-48 Non-plenum Wire 22 Awg

Product Description

The SUPERIOR ESSEX PW52-H46-48 is a 4-conductor, 22 AWG non-plenum composite wire supplied on a 1000-foot reel in white jacket. Designed for low-voltage signal and control wiring applications, this cable is suited for HVAC control runs, security systems, and general building automation wiring where plenum-rated cable is not required. The 22 AWG gauge provides reliable signal transmission over standard residential and light commercial run lengths. Licensed HVAC technicians, security installers, and low-voltage electricians are the primary trades that work with this wire type.

This cable is appropriate for use in non-plenum spaces such as conduit runs, wall cavities, and mechanical rooms where local codes permit non-plenum jacketed cable. It is commonly pulled for thermostat wiring, zone controller wiring, damper actuator runs, and similar low-voltage control applications in residential and light commercial HVAC systems. The 1000-foot reel length supports larger projects or multiple runs from a single source, reducing waste and reel changeovers on the job.

Key Features

• 4-conductor configuration supports multi-zone and multi-function control wiring
• 22 AWG gauge suitable for standard low-voltage control and signal runs
• 1000-foot reel minimizes changeovers on larger installations
• White jacket for clean appearance in finished spaces and easy identification
• Non-plenum rated jacket appropriate for conduit and non-air-handling spaces per applicable codes

Compatibility

Designed as an OEM-style non-plenum composite control cable for use in low-voltage HVAC, security, and building automation wiring applications in non-plenum environments.

Installation Notes

Installation should be performed by a licensed low-voltage electrician or qualified HVAC technician in accordance with NEC Article 725 and applicable local codes. Confirm that the installation location does not require plenum-rated cable before pulling this wire through air-handling spaces. De-energize all control circuits at the panel or disconnect before terminating conductors. Do not exceed the cable bend radius during pull-through to avoid conductor damage or jacket deformation.